with step 10.
Note
•
The control screw must be closed no later than when an ATF temperature of 45 °C is reached.
5. If no ATF escapes from the control bore even though approx. 40 °C has been reached, the ATF must be
topped up.
Note
•
To undo and tighten the cap nut for the charging valve, counter with an open−ended wrench.
6. Screw off cap nut for the charging
valve.
7. Screw special tool 9507/1 −A− onto the charging valve and top up ATF via the charging valve until
excess ATF emerges at the control bore.
8. Replace sealing ring for cap nut.
9. Screw on cap nut for charging valve.
Tightening torque: 40 Nm (30 ftlb.)
10. Screw in ATF control screw with a new sealing ring.
Tightening torque: 22 Nm (16 ftlb.)
top of page
Tightening torques
Location
Control screw to ATF pan
Cap nut to charging valve
996420, 996421, 996450, 996451, 996620, 996621, 996650, 996651
Tightening torques
einordnung
Thread
Tightening torque Nm (ftlb.)
M10
M14 x 1.5
22 (16)
40 (30)
93