Porsche 996 TT Repair Manual page 617

5. Insert vent line into distributor hose in the left front wheel well −2− and into coolant hose in the
right front wheel well and fit the spring−band clamps.
6. Clip vent line into the two holders−arrows− on the coolant pipes.
7. Fasten coolant pipes at front. To do this, insert two aluminium pipes and a vent line in the network
into the corresponding coolant hoses and fit the five spring−band clamps (1 clamp for vent line on
the distributor hose in the left front wheel well −Item 2− and four clamps for coolant pipes −Item
4 in next figure− ).
8. Mount four pipe holders using two M6 hexagon−head bolts and two M6 hexagon nuts −Items 1
and 3 in next Figure− and fix coolant pipes on the vehicle underbody in the holders. Push coolant
pipes into the coolant hoses to the engine, tighten the spring−band clamps and remove the hose
clamps again.
Tightening torque of the hexagon−head bolts M6: 10 Nm (7.5 ftlb.)
Note
• When lifting the suspension subframe, protect servo lines of the steering from damage
Installing fuel tank
einordnung
554