8. Disconnect electrical plug connections −A− and remove the selector
support.
Installing selector support
Note
•
Install in reverse order to removal.
1. Insert selector support and connect electrical plug connections.
2. Tighten fastening nuts.
Tightening torque: 10 Nm (7.5 ftlb.)
3. Insert support bracket sleeve on the selector lever cable in the support bracket on the selector support.
Make sure the two plastic clips engage properly. (See enlarged view).
4. Push selector lever cable all the way back (see enlarged view); this shifts the transmission into park.
5. Move selector lever to position P.
Removing selector support
einordnung
738