Installing lifting/sliding roof drive
Note
•
Do not press on or touch the transmission/reception diodes with your fingers!
•
The cover lenses must not be soiled or smudged with grease.
1. Engage electrical plug connection and carefully lay the wire (do not pinch).
Note
•
Always replace the fastening screws of the lifting/sliding roof drive after they have been loosened
(microencapsulated).
2. Position lifting/sliding roof drive in the teeth of the frame for the sliding roof and fasten with the Torx
fastening screws −arrows− . Tightening torque: −6 Nm (4.5 ftlb.)−
3. Engage cover on the windscreen frame at front and push rearward. Unclip locking tabs −arrows B− of the
cover on the left and right. Tighten fastening screws with a crosshead screwdriver −A− .
4. Fit cover lenses.
top of page
Installing lifting/sliding roof drive
einordnung
910