Installing Hall Sender - Porsche 996 TT Repair Manual

Sheetmetal nuts on heat shield
3. Remove the shields above the plug coils. Unscrew the two hexagon−head bolts for this purpose.
4. Disconnect plug connection on hall sender by pressing the cable connector up using a long screwdriver, if
necessary.
5. Unscrew hexagon socket head bolt on hall sender.
6. Remove the hall sender.
top of page

Installing hall sender

Note
• The hexagon socket head bolt is micro−encapsulated and so must always be replaced!
• Replace sealing ring on hall sender.
1. Place new sealing ring over the hall sender, position hall sender, then screw in and tighten the new
hexagon socket head bolt.
Tightening torque: 10 Nm (7.5 ftlb.)
Removing hall sender
einordnung
654