Tightening Torques - Porsche 996 TT Repair Manual

Screw in the fastening
screws −B− at the side
(vehicles with roof frame
reinforcement in the body
structure)
2 Screw in the front
fastening screws −A−
2a Screw in the fastening
screws of the holder −C−
at the side
(vehicles without roof
frame reinforcement in
the body structure)
Tighten the fastening
screws with the correct
tightening torque
3 Connecting electrical plug
connection
4 Push on water drain hoses Push the water drain hoses at the front and rear onto the water drain
Installing sliding roof
panel
Installing roof lining

Tightening torques

Location
Fastening screw, sliding roof frame to roof frame
reinforcement
Fastening screw, sliding roof holder to roof frame, at
side
Fastening screw, sliding roof frame holder to sliding
roof frame
996420, 996421, 996450, 996451, 996430, 996431, 996840, 996841
Tightening torques
einordnung
Position the fastening screw of the sliding roof frame at the side and
tighten by hand.
Position the fastening screws on the sliding roof frame at the front and
tighten by hand.
Position the fastening screws of the retaining brackets −C− . Align the
retaining bracket laterally with the sliding roof frame and the roof
frame −arrows− . Tighten the fastening screws of the retaining
brackets −D− with the correct tightening torque according to the
following table.
Tighten all fastening screws according to the following table.
Plug in the electrical plug connection. The locking tabs −arrow E−
must engage on both sides when the connection is made.
brackets of the frame for the sliding roof.
=> Removing and installing sliding roof panel
' 708419 Removing and installing roof lining
Illustration Thread
−A− M6
−B, C− M6
−D− M6
Tightening torque Nm
(ftlb.)
7.5 (5.5)
7,5 (5.5)
7.5 (5.5)
916