Porsche 996 TT Repair Manual page 711

7. Separate the B+ disconnection point −arrow− under the cover for this purpose. Unscrew the left fastening
screw. Unscrew the right fastening screw by approx. 1 cm. Then drive it in with gentle taps of a hammer
until the screw head makes contact with the generator again. Now unscrew fastening screw completely.
Lift the generator upwards out of the engine compartment.
8. Remove air conditioning compressor from the bracket for the generator. Unscrew the three screws
−arrows− for this purpose. The throttle body can be swung upward for better accessibility to the
front screw. To do this, the two hose clamps must be removed.
Note
Do not open air conditioning system!
•
9. Remove the compressor. Disconnect the electrical connection on the compressor. Unplug compressor. Lift
the compressor out of the engine compartment and lay it aside with the leads still connected. Protect the
body from damage with a cover.
10. Unclip coolant hose. To do this, unclip the safety bracket on the coolant neck with a screwdriver and pull
the coolant hose up and out.
11. Detach the coolant outlet neck of cylinder bank 4 to 6. Undo the two hexagon−head bolts on the coolant
outlet neck for this purpose.
12. Detach bracket for generator. Unscrew the four fastening screws −arrows− on the bracket for the
generator.
Removal
einordnung
648