Installing The Three−Phase Generator; Undoing And Tightening The Belt Pulley; Tool For Holding The Free−Wheel Pulley - Porsche 996 TT Repair Manual

top of page
Installing the three−phase generator
1. Fasten B+ lead and install three−phase generator.
2. The B+ lead must be fastened onto the long wiring arrangement −(arrow)− of the three−phase
generator (see Figure).
3. Install deflection roller and fit drive
belt.
Tightening torque of the hexagon nut M16 x 1.5: 65± 5 Nm (48 ± 3.5 ftlb)
Tightening torque of the hexagon−head bolts M10: 46 Nm (34 ftlb.)
Tightening torque of the M8 hexagon nut: 15 Nm (11 ftlb.)
Tightening torque of the deflection roller M10: 46 Nm (34 ftlb.)
4. Install air flow sensor with air cleaner assembly and connect
battery.
5. Perform a function test.
top of page

Undoing and tightening the belt pulley

Note
• The belt pulley can be undone or tightened using a standard commercially available tool.
• Double offset ring wrench a/f 24
• Screwdriver insert for internal serration screw a/f 10
• Cross handle and torque wrench
1. The hexagon nut a/f 24 must be countered with the ring wrench during
tightening.
2. The shaft is tightened to the prescribed tightening torque of 65 ± 5 Nm ( 48 ± 3.5 ftlb.) using the
screwdriver insert and the torque wrench.
top of page
Tool for holding the free−wheel pulley
Note
Removing the three−phase generator
einordnung
644