21 67 19 Removing and installing bypass flap control
box on the turbocharger − Engine installed
Removing bypass flap control box on the turbocharger
Installing bypass flap control box on the turbocharger
top of page
Removing bypass flap control box on the turbocharger
CAUTION
•
Danger of burns! Parts of the exhaust system can be extremely hot.
•
Do not begin work until the exhaust system has cooled down or wear suitable protective gloves!
1. Remove safety bracket on the push rod. To do so, carefully pull off the safety bracket with a screwdriver.
2. Loosen and then unscrew the nut on the push rod, and pull the push rod out of the release.
3. Remove vacuum hose from the control box. Push a small screwdriver between connection nipple and
vacuum hose. Widen vacuum hose a little and spray in silicone spray at the same time. Pull off vacuum
hose.
21 67 19 Removing and installing bypass flap control box on the turbocharger − Engine installed 588