Installing Atf Filter - Porsche 996 TT Repair Manual

3. Disengage cable on the retaining clips of the ATF
pan.
4. Place oil collection pan under the transmission.
5. Unscrew drain screw −A− and drain ATF.
Note
• Without ATF, the engine must not be started and the vehicle must not be towed.
6. Remove ATF pan (loosen screws crosswise).
7. Remove ATF filter.
top of page

Installing ATF filter

1. Thinly coat gasket on the suction collar of the new ATF filter with Vaseline and install
filter.
2. Clean ATF pan.
3. Fit ATF pan with new seal. Tighten the screws crosswise in several stages.
Tightening torque: 8 Nm (6 ftlb.)
4. Replace sealing ring for ATF drain plug and tighten screw.
Tightening torque: 22 Nm (16 ftlb.)
5. Fill in ATF. => Checking and topping up the ATF
6. Engage cable on the retaining clips of the ATF
pan.
7. Install cross member.
Tightening torque: 65 Nm (48 ftlb.)
8. Install rear underside
panel.
Removing ATF filter
einordnung
98