Notes For Sliding Piece And Airbag Contact Unit - Porsche 996 TT Repair Manual

• Observe note on steering−gear centre position in the section describing front track adjustment in
Repair Group 44!
Note
When topping up or filling in Pentosin, make sure that it does not come into contact with the coolant
•
hoses! Observe the specifications in order to avoid overfilling and thus overflowing!
• If coolant hoses come into contact with Pentosin, thoroughly clean them with water
IMMEDIATELY!
• Replace visibly swollen coolant hoses!
• After fitting the pressure lines, fill steering hydraulics with Pentosin CHF 11 S and bleed steering
system.
• Tighten all screw connections with the prescribed tightening torque values.
• Check and/or adjust track.

Notes for sliding piece and airbag contact unit

1. If sliding piece No. −1− was pulled off steering shaft No. −4− , notch No. −2− must point to the
tooth gap No. −3− on assembly.
WARNING
Malfunctions of the driver's airbag unit possible!
Do not trap the cable of the contact unit! Ensure correct routing!
2. If the steering wheel was not fixed before the steering gear was removed, the position of the contact
unit (spiral spring) may no longer be correct. In this event, remove steering wheel and move contact
unit to centre position!
Centre position:
3. First move contact unit against the end stop.
Installation
einordnung
848