Position the sliding/tilting roof trim −dimension A− approx. 80 mm in front of the roof edge cut−out.
Disengage left and right inner side panels. Pull out the connector springs −B− on the gate and pull
the sliding/tilting roof trim upwards.
Push the sides of the inner panels out of the sliding roof frame inwards (centre of the
vehicle).
top of page
Additional instructions for fitting the inner panels
Installing inner panels
Press the sides of the inner panel into the sliding roof frame. Check function by sliding longitudinally.
Pull out the connector springs −B− on the gate and push in sliding/tilting roof trim. Push inner
panels under the sheetmetal panel of the sliding/tilting roof trim.
Additional instructions for fitting the inner panels
einordnung
925