Fitting - Porsche 996 TT Repair Manual

Note
• Socket wrench insert 9259 is required for removal and installation of the airbag triggering unit.
9. Undo the fastening screws −arrows− on both sides and remove the holder −2− . To do this, guide
the electrical wiring and, if necessary, the keylock cable through the holder opening.
top of page

Fitting

CAUTION
The rate−of−turn sensor is a micro−mechanical component and is very sensitive to impacts!
1. Install new/current holder −B− dimension X = approx. 60 mm (6 fastening screws). Dimension X of the
holder for the first version −A− is approx. 110 mm. To do this, guide the electrical wiring and, if
necessary, the keylock cable through the holder opening. Fit the plastic clips and the clips from the old
holder on the new holder.
2. Install airbag control unit. Use new shear−off nuts.
Tightening torque of the M6 hexagon nut: 10 Nm (7.5 ftlb.)
Fitting
einordnung
796