Release
bearing
4
Spring
1
washer
5
Spacer
2
washer
6
Thrust plate
1
top of page
Removing release bearing
1. The release bearing is removed under a shop press. For this purpose, lay the release bearing down on
the bottom and press down on the pressure plate from above with a pressure piece (e.g. hardwood
block) until the snap ring can move freely.
2. Remove snap ring and take out release bearing.
top of page
Installing release bearing
Note
Do not grease the sliding surfaces of the release bearing and the guide tube.
•
Removing release bearing
einordnung
Mount in correct position
Fit 2 spacer washers
Check for wear, replace if
necessary
680