Pressing Ring Knurled Screw In; Assembling Crankshaft - Porsche 996 TT Repair Manual

1. Clamp the con−rod cover into a machine vice. Press both 4−ring knurled screws out at the same time.

Pressing ring knurled screw in

CAUTION
In order to avoid damage to the joint face, always use an aluminium sleeve, e.g. from the special tool set P140
(retainer sleeves for cylinders).
1. Guide the new 4−ring knurled screw by hand into the previous (old) toothing and then press it in up to the
rest.
2. Re−allocate the con−rod cover and the connecting rod and lay to one side.
top of page

Assembling crankshaft

1. Clean crankshaft thoroughly.
2. Rinse out oil bores with a hand pump and solvent naphtha several times.
3. With a visual inspection, check whether the oil ducts are blocked at the bearing surfaces and on the front
face (aluminium stoppers).
4. Clamp
crankshaft.
Pressing ring knurled screw out
einordnung
436