Installation - Porsche 996 TT Repair Manual

Installation

1. Install in reverse order.
2. Bleed the brakes ' 47 01 07 .
Note
• First bleed brakes as usual!
• Do not carry out booster pump activation with the Porsche System Tester 2 until after this has been
done (after conventional bleeding) as otherwise damage to the booster pump can occur!
To bleed at front on right with running booster pump, the bleeding device should remain connected
•
(switched on)! Bleeding pressure approximately 2.0 bar!
3. Carry out the following tests:
Read out and erase the fault memory of the PSM control module with the Porsche System Tester 2.
Carry out a static test.
Then start the engine. The PSM−related lights in the instrument cluster must go out when the engine is
running.
Read out the PSM fault memory again. There must not be any stored
faults.
996420, 996421, 996450, 996451, 996620, 996621, 996650, 996651
Installation
einordnung
808