Tightening Torques - Porsche 996 TT Repair Manual

7. Connect the Porsche System Tester 2 and call up the ATF temperature.
8. Move selector lever to position "P" and allow engine to idle.
9. With engine running, top up ATF again until excess ATF emerges from the bore of the ATF control
screw −B− .
10. With the brake pedal pressed, change through all selector lever positions, remaining in each position for
approx. 10 s.
Note
• The ATF temperature must not be higher than 40 °C at the start of the test.
11. Check the ATF level again and top up if necessary. => Checking and topping up the ATF
12. Replace sealing ring for cap nut and screw cap nut onto the charging valve.
Tightening torque: 40 Nm (30 ftlb.)
13. Screw in the ATF control screw with a new sealing ring and tighten it to 20 Nm (15 ftlb.).
Tightening torque: 22 Nm (16 ftlb.)
top of page

Tightening torques

Location
Drain plug to ATF pan
Control screw to ATF pan
Cap nut to charging valve
996420, 996421, 996450, 996451, 996620, 996621, 996650, 996651
Tightening torques
einordnung
Thread Tightening torque Nm (ftlb.)
M10
M10
M14 x 1.5
22 (16)
22 (16)
40 (30)
96