11 19 Removing And Installing Front Speed Sensors; Removal; Installation - Porsche 996 TT Repair Manual

45 11 19 Removing and installing front speed sensors

Removal

Installation

top of page
Removal
1. With ignition switched off, open the combination plug connection at the spring strut and pull out
the plug for the speed sensor.
2. Loosen fastening screw (hexagon socket head bolt) and remove the speed sensor.
top of page
Installation
Note
Before installation, ensure that there are no metal chips at the magnetic edge of the speed sensor!
•
• The gap between speed sensor and pulse wheel is determined by the design and cannot be adjusted!
• There is no O−ring between speed sensor and wheel carrier!
• The speed sensors at front and rear axles are the same!
1. Coat speed sensor and the bore in the wheel carrier with Molykote Longterm 2.
2. Without using excessive force, insert speed sensor into wheel carrier and tighten the hexagon socket head
bolt to 10 Nm (7.5 ftlb.).
3. If the speed sensor has been removed or replaced due to an ABS fault or Traction Contol fault, or because
of accident repairs, a functional check should be carried out with the Porsche System Tester 2
Actual Values menu, Speed submenu.
996420, 996421, 996450, 996451, 996620, 996621, 996650, 996651, 996840, 996841
45 11 19 Removing and installing front speed sensors
via the
781