Tightening Torques For Front Axle And Fuel Tank - Porsche 996 TT Repair Manual

16. Tighten hexagon−head bolt M6 x 12 of the filler neck −arrow− . Coat seat of the cap seal with Vaseline.
Tightening torque 10 Nm (7.5 ftlb.)
17. Fill and bleed cooling system ' 19 38 17 Filling and bleeding the cooling system .
18. Refill fuel tank.
19. Calibrate fuel level sensor system => Calibrating fuel level sensor system.
20. Install front wheel housing liners ' 50 56 19 Removing and installing front wheel housing liner .
Note
• Observe specification for greasing wheel bolts ' 44 05 19 Removing and installing wheel .
21. Fit the front wheels, using the prescribed special tool socket wrench insert P 300 to avoid damage to
the wheels.
Tightening torque of the wheel bolts : 130 Nm (96 ftlb.).
22. Connect the battery ' 9 Work instructions after disconnecting the battery .
23. Remove steering wheel holder.
24. Check wheel arch values. In the case of deviations, perform a suspension alignment if necesary and
adjust ' 44 Wheels, tires, suspension alignment .

Tightening torques for front axle and fuel tank

Location
Cross member/side member on body (front and rear)
Corner plate on body
Diagonal brace on body and side member
Front−axle drive shaft to final drive
Rear front−axle transmission support to body
Front front−axle transmission support to front−axle cross
member
Stud to front−axle cross member
Tank strap to body
Stabilizer mount to stabilizer
Universal joint (steering shaft) to steering gear
Steering gear to cross member
Tightening torques for front axle and fuel tank
einordnung
Thread
M14 x 1.5
M12 x 1.5
M12 x 1.5
M8
M10
M10
M8
M8
M10
M8
M10 x 1.5
Tightening torque Nm
(ftlb.)
160
100
100
39
65
65
20
23
46
23
65
557