Cylinder sleeve application
20. Lift connecting rod of cylinder 4, 5 and 6 with restraining straps, special tool P221. Lift timing chain with
tension strap.
21. Coat both sides of sealing rings on the oil pump (2 pieces) and the sealing ring on the crankcase half with
vaseline and insert.
22. Prepare crankcase halves of the cylinder bank 1 − 3. To do this, insert the bearing shells of the crankshaft
and the intermediate shaft.
Degrease the sealing surface of the crankcase halves. Apply a uniform bead of silicone (Drei Bond Typ
1209) approximately 1.5 mm wide to the sealing surface of the crankcase half of cylinder bank 1 − 3.
Assembling the crankcase.
einordnung
405