Installation - Porsche 996 TT Repair Manual

top of page

Installation

1. Put the two hose clamps back onto the connections which lead to the radiators. Fit the hose clamp
above the lower flange.
Note
• In order to facilitate fitting, wet the inside of the coolant hose with water in the fitting area and push
the hose onto the coolant pipes.
2. Return the Y−type distributor to installation position and push on the three connections.
3. Refit the rear hose clamp on the connection point of the Y−type distributor and on the coolant pipe of the
middle radiator.
4. Re−position the hose clamp between the Y−type distributor and the left radiator. Tighten the hose clamp.
5. Re−position the lower hose clamp on the Y−type distributor and
tighten it.
6. Push the −locking clip− back onto the radiator flanges. Make sure that the locking clip has been properly
inserted when doing this.
7. Position the coolant line in relation to the left radiator and clip the holder in again.
8. Replace the O−ring on the coolant hose flange.
Installation
einordnung
540