Porsche 996 TT Repair Manual page 614

M10 x 1.5 a/f 15 (on the underside of the suspension subframe) −5− and press off the steering gear ' 48
90 19 Removing and installing steering gear .
14. Support suspension subframe with a transmission jack. Pull off the cable plug on the sensor of the
headlight beam adjustment −right arrow− . Detach stabilizer from the mount. To do this, remove the
hexagon nut M10 from each joint −left arrow in the Figure− , countering with an open−ended wrench at
the joint hexagon.
15. Detach suspension subframe. Undo the six hexagon−head bolts at the front and rear −Items 2, 6 and 7−
and lower complete suspension subframe by approx. 15 cm.
16. Disconnect all coolant lines. To do this, undo the four spring−band clamps −Item 4, upper part of
Figure− on the coolant hoses at the front and pull off the coolant pipes.
17. Undo a spring−band clamp for the vent line on the distributor hose in the left front wheel well −1− .
Remove coolant pipe.
18. Pull off vent line from distributor hose in the left front wheel well −Item 2, previous Figure− and unclip
from the two holders under the fuel tank −arrow− . Remove line on the coolant hose in the right front
Removing fuel tank
einordnung
551