28 39 19 Removing and installing hall sender −
Engine installed
Caution
Removing hall sender
Installing hall sender
Tightening torques
WARNING
•
Danger of burns! Parts of the exhaust system can be extremely hot.
•
Do not begin work until the exhaust system has cooled down or wear suitable protective gloves!
Danger of fire! The heat shield should not be bent or deformed. Bent or deformed heat shields must
•
be replaced!
Note
•
The work procedures apply to both sides of the vehicle.
top of page
Removing hall sender
Preliminary work:
Remove rear spoiler. ' 635519 Removing and installing rear spoiler
1. Remove charge air cooler. => Removing and installing the charge air cooler
WARNING
Danger of fire! The heat shield should not be bent or deformed. Bent or deformed heat shields must be
replaced!
2. Remove side heat shield by undoing the bolts on the heat shield. Undo the two sheetmetal nuts on
the lower end of the heat shield. Then, press the heat shield out of the studs. See partial description
in chapter ' 635019 Removing and installing rear bumper.
28 39 19 Removing and installing hall sender − Engine installed
653