Porsche 996 TT Repair Manual page 670

15. Remove special tool (retaining device) 9624/1 .
16. Fasten stabilizer.
17. Install rear mufflers with new seals. The seals between the exhaust turbochargers and the rear muffler
must be replaced. Move the rear muffler into installation position and push the two tensioning straps over
the holder on the engine carrier. Subsequently tighten the two hexagon socket head bolts slightly.
18. Push the heat shields over the studs of the exhaust turbocharger. Fit new hexagon nuts.
Tightening torque 30 Nm (22 ftlb.).
19. Tighten restraining straps on the rear muffler.
Tightening torque 15 Nm (11.0 ftlb.).
20. Fit heat shields, bumper and rear spoiler.
21. Install bracket for the generator. Replace the four O−rings on the two connecting flanges between
the two coolant outlet necks of cylinder bank 1−3. Then screw in the four fastening screws.
Important: The front right screw must be inserted with Loctite 574 (as shown in the illustration).
Tightening torque 65 Nm (48 ftlb.).
Installation
einordnung
607