Porsche 996 TT Repair Manual page 467

einordnung
Prepare four tension rod bolts. Push sealing washers on to tension rod bolts. Feed lightly oiled
O−rings with conical sleeve from special tool 9511 over the threaded area and push them on to the
tapered section towards the head of the bolt.
Observe the A side and B side on the assembly sleeve 9511.
Insert the prepared tension rod bolts into the right crankcase half from below as far as they will go and
retain in this position.
Place conical sleeve on end of the thread. Push O−ring (dry) over the conical sleeve. Remove conical
sleeve and push the O−ring with the cylinder sleeve as far as the chamfer in the thrust block. Remove
cylinder sleeve.
Assembling the crankcase. 404