5. Remove snap ring with snap ring
pliers.
6. Remove spacer ring and timing gear with a conventional puller.
7. Raise Woodruff key with side cutters and remove.
8. Remove crankshaft from retaining plate.
9. Check crankshaft for shocks, cracks and wear.
10. Carry out sounding test.
Note
•
Before assembling the connecting rods, check without fail the elongation of the ring knurled screws.
If the dimension X (38.3 mm) is exceeded, the connecting−rod bolts must be replaced.
11. Check the connecting rods. Determine the length of the connecting−rod bolts.
Note
In the case of the connecting−rod version with a 3−ring knurled screw, no replacement is possible. In
•
this case, the entire connecting rod must be replaced. The 4−ring knurled screw is available as a spare
part.
Identifying the ring knurled screw
Identifying the ring knurled screw
einordnung
434