Installation - Porsche 996 TT Repair Manual

Cross member at front to side section
Drive shaft to transmission
top of page

Installation

Note
• Before installing the slave cylinder, it is sensible to remove the starter! This guarantees a better test
and the unequivocal centring of the tappet push rod of the slave cylinder in the release lever! The
slave cylinder can also be held in its installation position from this side!
• Observe the precise position of the slave cylinder before installation! The precise installation position
is attained by turning in the vehicle!
The loosely attached transmission slave cylinder bracket ensures the correct installation height for
•
positioning the slave cylinder screws!
1. Remove the starter ' 276019 Removing and installing
starter .
2. Remove the top cover (rubber cap) on the clutch housing in the area of the release lever.
3. Insert the clutch slave cylinder into the vehicle with the pushrod facing towards the transmission
and turn it into its installation position.
4. Fasten the transmission−slave cylinder bracket loosely to the slave cylinder with a screw. It is very
difficult to attach the screw later.
5. Install the clutch slave cylinder to the transmission housing/release lever. Pay attention to the
correct position of the pushrod! Do not tighten the fastening screws yet. This ensures better access
to the pressure line.
6. Place pressure line in position.
7. Tighten the pressure line and screw the slave cylinder
tight.
8. Insert the return line.
9. Install the hose of the master cylinder line on the slave cylinder.
10. Screw the master cylinder line together −arrow− and insert it into the guide on the body.
11. Install the pressure reservoir.
12. Position the input shaft on the transmission flange and tighten with 81 Nm (60 ftlb.).
13. Install the bracket for the water hoses and clip the hoses into place. Align the hoses.
Installation
einordnung
M10 x 1.5
M10
65 (48)
81 (60)
674