15 03 23 Installing camshaft housing
Refer to tools and tightening torques in Chapter "Removing camshaft housing"!
1. Replace seals. Replace the seals between the chain box/camshaft housing and the cylinder
head/camshaft housing seal. The embossed recesses in the seal must face the cylinder head.
2. Place the camshaft housing in position. Carefully put the camshaft housing on in a staight line. When
doing so, make sure that the flat−based tappet guides are not damaged.
Note
If screws of strength class 8.8 have been installed, these must be replaced by screws of strength class
•
10.9.
3. Mount the 18 hexagon−head bolts. The bolts are tightened in two stages in the order specified.
•
Initial tightening: 23 Nm (17 ftlb.)
•
Final tightening: 28 Nm (21 ftlb.)
4. Insert flat−based tappets. Spread a thin coat of clean engine oil on the flat−base tappets. Do not
interchange the flat−base tappets. In the case of the flat−base tappets for the inlet camshaft, make sure that
the feather keys are positioned in the grooves in the flat−base tappet housing.
5.
15 03 23 Installing camshaft housing
458