Xn120 Pc Programming Tool; Installing The Xn120 Programming Tool - NEC XN120 Getting Started Manual

XN120 PC Programming Tool

2. XN120 PC Programming Tool

Installing the XN120 programming tool

Minimum Requirements
The Topaz PCPro will be installed into the following PC specifications;
1 Processor
2 RAM
3 Hard Disk Drive
Space
4 Monitor Resolution
5 OS
(Operating System)
6 Drive
7 Others
Important Points
1. Only one person is allowed in programming mode at a time. An error message will be
received if trying to log on while another user is already in programming mode.
2. When updating the PCPro software, it is recommended that you should first remove the
existing software version.
3. After connect PC with Topaz System, if nothing is carried out about 15 minutes, a session
will be cut off by Topaz main software.
Procedure
1. Insert the XN120 Technical Support CD into the CD-ROM Drive of your PC.
2. From My Computer, Click CD drive and Click" Setup exe" to start the installation.
3. Click Next> to appear the License Agreement. Click Check box.
4
Pentium II 500MHz equivalent or higher
128MB
20MB
800 X 600 pixels or higher
Microsoft Windows 98SE/2000/XP
CD-ROM Drive
Mouse
(depending on connection type)
NIC - Network Interface Card
Serial COM port