Installing The Voice Messaging System Boards - NEC Xen IPK Installation Manual

Hide thumbs Also See for Xen IPK:
Table of Contents

Advertisement

Xen IPK Xen Mail CTI Installation Guide
S
3
E C T I O N
I
NSTALLING THE VOICE
MESSAGING SYSTEM
BOARDS
Setting Up the System
The voice messaging system board provides all voice messaging system
application functions and voice recording storage on their hard disks.
To install the voice messaging system board in the phone system, perform
the following procedure. For an illustration of the main board used for all
systems, see "About the system board."
To install the voice messaging system board(s)
1 Turn off the phone system.
2 Insert the board halfway into any available slot in the phone system.
3 Do one of the following:
• To access the voice messaging system screens using a monitor, keyboard,
and mouse, plug these devices into the appropriate locations on the voice
messaging system board.
• To access the voice messaging system screens using a remote access con-
nection, set SW3 dip switch #2 Off for a direct connection or On for a modem
connection.
4 Confirm the SW3 dip switch #1 and #2 are set Off and switch #3 and #4
are set On.
5 Insert the board all the way into the slot.
6 Confirm the Shutdown switch is set On.
7 Turn on the phone system. When the software LED lights, the voice
messaging system is running and ready for use. The system may take
5-10 minutes to start.
Chapter 2 - 7

Advertisement

Table of Contents
loading

Table of Contents