Operation Mode Selection - YASKAWA V1000 Series Installation & Start-Up Manual

No. Name
Frequency Reference
b1-01
Selection 1
Run Command
b1-02
Selection 1
Stopping Method
b1-03
Selection
Reverse Operation
b1-04
Selection
Local/Remote Run
b1-07
Selection
Run Command
b1-08 Selection while in
Programming Mode
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
Description
b1: Operation Mode Selection
Use b1 parameters to configure the operation mode.
Selects the frequency reference input source.
0: Operator - Digital preset speed d1-01 to d1-
17.
1: Terminals - Analog input terminal A1 or A2.
2: Memobus communications
3: Option PCB
4: Pulse Input (Terminal RP)
Selects the run command input source.
0: Operator - RUN and STOP keys on the
digital operator.
1: Digital input terminals S1 to S7
2: Memobus communications
3: Option PCB.
Selects the stopping method when the run
command is removed.
0: Ramp to Stop
1: Coast to Stop
2: DC Injection Braking to Stop
3: Coast with Timer (A new run command is
ignored if received before the timer expires)
Permits or prohibits reverse operation.
0: Reverse enabled.
1: Reverse disabled.
Determines the operation when the Run
command source is switched from LOCAL to
REMOTE or between Run source 1 and 2
while an external Run command is active at the
new source.
0: External Run command has to be cycled at
the new source to be activated.
1: External Run command at new source is
accepted immediately.
0: Run command accepted only in the
operation menu.
1: Run command accepted in all menus.
2: Prohibit entering programming mode during
Run
B.2 Parameter Table
Control
Mode
Range Def. Addr.
O
V/ P
Hex
L
f M
V
0 to 4 1 S S S 180
0 to 3 1 S S S 181
0 to 3 0 S S S 182
DC Injection Braking at Stop
cannot be selected when using
Open Loop Vector for PM motors.
0,1 0 A A A 183
0,1 0 A A A 186
0 to 2 0 A A A 187
Pg.
124
127
129
—
B
—
—
309