Communication Set-Up Procedure; Control Circuit Terminal Block Configuration - YASKAWA V1000 Series Installation & Start-Up Manual

Figure C.4
Figure C.4 Control Circuit Terminal Block Configuration
(CIMR-VA
◆

Communication Set-Up Procedure

Use the following procedure to communicate with the PLC.
1.
Turn OFF the input to the drive power and connect the communication cable
between the PLC (or other master device) and the drive.
2.
Turn ON the input power to the drive.
3.
Set the required communication parameters (H5-01 to H5-07) using the Digital
Operator.
4.
Turn OFF the input to the drive power, and check that the Digital Operator display
has completely extinguished.
5.
Turn ON the input power to the drive once again.
6.
Perform communication with the master device.
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
C.1 MEMOBUS/Modbus Basic Set-Up
R+ R S+ S IG
P1 P2 PC A1 A2 +V AC AM AC MP
S1 S2 S3 S4 S5 S6 S7 HC SC
MA MB
H1 RP
; CIMR-VU
MC
)
C
405