Remove The Conduit Bracket On An Ip20/Open-Chassis Drive - YASKAWA V1000 Series Installation & Start-Up Manual

3.5 Protective Covers
Figure 3.15
A
Figure 3.15 Remove the Conduit Bracket on an IP20/Open-Chassis Drive
Reattaching the Protective Covers
■
Pass power wiring and control signal wiring through the exit holes on the bottom of the
conduit bracket of the drive. Place power wiring and control signal wiring in separate
conduits. Properly connect all wiring after installing the drive and connecting other devices.
Reattach all protective covers when wiring is complete.
Figure 3.16
A
A – Pass power wiring and control signal wiring through different
exit holes at the bottom of the drive.
Figure 3.16 Reattach the Protective Covers and
Conduit Bracket on an IP20/NEMA Type 1 Drive
64 YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual