Run The Drive Using Digital Input Terminals: B1-02 = 1; Using A 2-Wire Sequence; Using A 3-Wire Sequence; Example Wiring Diagram For 2-Wire Sequence - YASKAWA V1000 Series Installation & Start-Up Manual

4.6 Basic Drive Setup Adjustments
4. The motor should accelerate up to 6 Hz while the RUN light is on.
5. Press the
STOP
until the motor comes to a complete stop.

Run the Drive using Digital Input Terminals: b1-02 = 1

■
This setting uses the digital input terminals to enter the run command. The factory setting is
a 2-wire sequence.

Using a 2-Wire Sequence

Digital Input Terminals
S1
S2
Figure 4.15

Using a 3-Wire Sequence

When H1-05 (Multi-Function Digital Input Terminal S5 Function Selection) = 0, the
functions of terminals S1 and S2 are set to 3-wire sequence, and the multi-function input
terminal becomes forward/reverse run command terminal.
128
Step
key to stop the motor. The RUN light will flash
Forward Run
Reverse Run
Figure 4.15 Example Wiring Diagram for 2-Wire Sequence
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
ON
Forward Run
Reverse Run
Drive
S1
S2
SC Digital Input Common
Display/Result
⇒
STOP
off
⇒
flashing
OFF
Stop
Stop
on
off