Crane Application (Travel): Parameters And Settings - YASKAWA V1000 Series Installation & Start-Up Manual

No.
L3-04
L4-01
L4-02
L6-01
L6-02
L6-03
L8-05
L8-07
L8-38
L8-41
Note: A sequence to release the brake is needed when the multi-function output photocoupler P2-PC
closes. Refer to Hoist Application Preset Specifics on page 118
Note: Perform Auto-Tuning after selecting the Hoist Application Preset.
Table 4.16 Parameters Automatically Saved as Preferred (A2-01 to A2-16)
No.
A1-02 Control Method Selection
b1-01 Frequency Reference Selection
b6-01 Dwell Reference at Start
b6-02
C1-01
C1-02
C6-02 Carrier Frequency Selection
d1-01
Note: Read the instructions listed in
Application Preset.
Table 4.17 Crane Application (Travel): Parameters and Settings
No.
A1-02
b1-01
C1-01
C1-02
C6-01
C6-02
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
Parameter Name
Momentary Power Loss Voltage Recovery Ramp
Time
Speed Agreement Detection Level
Speed Agreement Detection Width
Torque Detection Selection 1
Torque Detection Level 1
Torque Detection Time 1
Input Phase Loss Protection Selection
Output Phase Loss Protection
Carrier Frequency Reduction
Current Alarm Selection
Parameter Name
Dwell Time at Start
Acceleration Time 1
Deceleration Time 1
Frequency Reference 1
Hoist Application Preset Specifics on page 118
Parameter Name
Control Mode
Frequency Reference Selection
Acceleration Time 1
Deceleration Time 1
Duty Cycle
Carrier Frequency Selection
4.5 Application Presets
Optimum Setting
8: UL3 at RUN -Fault
0: Derated when operating at 6 Hz or
1: Enabled (alarm is output)
for more information.
No. Parameter Name
d1-02 Frequency Reference 2
d1-03 Frequency Reference 3
E1-08 Mid Output Frequency Voltage (VC)
Terminals MA, MB, and MC Function
H2-01
L1-01 Motor Overload Protection Selection
L4-01 Speed Agreement Detection Level
L6-02 Torque Detection Level 1
L6-03 Torque Detection Time 1
when using Hoist
Optimum Setting
2: Open Loop Vector
0: Heavy Duty
0: Disabled
2.0 Hz
0.0 Hz
5%
0.5 s
1: Enabled
1: Enabled
less
Selection
0: Operator
3.0 s
3.0 s
2: 5 kHz
117
4