Options; Simple Pg V/F Parameters - YASKAWA V1000 Series Installation & Start-Up Manual

<52> Parameter ignored when E3-11, Motor 2 Mid Output Frequency 2, and E3-12, Motor 2 Mid Output Frequency
Voltage 2, are set to 0.
<53> Default setting depends on the control mode for motor 2 set in parameter E3-01. The given value is for V/f
control.
<57> Default setting value is dependent on parameter o2-04, Drive/kVA Selection and C6-01, Drive Duty Selection..
◆
F: Options
F parameters are used to program the drive for PG feedback and to function with option
cards.
No. Name
Use F1 parameters to set up the drive for Simple PG V/f control. These parameters are enabled only when H6-01 = 03
Operation Selection at
F1-02 PG Open Circuit
(PGO)
Operation Selection at
F1-03
Overspeed (OS)
Operation Selection at
F1-04
Deviation
Overspeed Detection
F1-08
Level
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
Description
F1: Simple PG V/f Parameters
Sets stopping method when a PG open circuit
fault (PGO) occurs. Refer to parameter F1-14.
0: Ramp to Stop - Decelerate to stop using the
active deceleration time.
1: Coast to Stop
2: Fast-stop - Decelerate to stop using the
deceleration time in C1-09.
3: Alarm only - Drive continues operation.
Sets the stopping method when an overspeed
(OS) fault occurs. Refer to F1-08 and F1-09.
0: Ramp to stop - Decelerate to stop using the
active deceleration time.
1: Coast to stop
2: Fast - Stop - Decelerate to stop using the
deceleration time in C1-09.
3: Alarm Only - Drive continues operation.
Sets the stopping method when a speed
deviation (DEV) fault occurs. Refer to F1-10
and F1-11.
0: Ramp to stop - Decelerate to stop using the
active deceleration time.
1: Coast to stop
2: Fast-stop - Decelerate to stop using the
deceleration time in C1-09.
3: Alarm only - Drive continues operation.
Sets the speed feedback level which has to be
exceeded for the time set in F1-09 before an
OS fault will occur.
Set as a percentage of the maximum output
frequency (E1-04).
B.2 Parameter Table
Control
Mode
Range Def. Addr.
O
V/ P
Hex
L
f M
V
A − −
0 to 3 1 381
A − −
0 to 3 1 382
A − −
0 to 3 3 383
115
A − −
0 to 120 387
%
Pg.
—
—
B
—
—
333