H2: Multi-Function Digital Outputs; H2 Multi-Function Digital Output Settings - YASKAWA V1000 Series Installation & Start-Up Manual

No. Name
Use H2 parameters to assign functions to the multi-function digital outputs.
Terminal MA, MB and MC
H2-01
Function Selection (relay)
Terminal P1 Function Selection
H2-02
(open-collector)
Terminal P2 Function Selection
H2-03
(open-collector)
H2-06 Watt Hour Output Unit Selection
<40> The availability of certain functions depends on the control method used.
H2-
Function
Setting
0 During Run
1 Zero Speed
2 Fref/Fout Agree 1
3 Fref/Fset Agree 1
Frequency (FOUT)
4
Detection 1
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
Description

H2: Multi-Function Digital Outputs

Refer to "Multi-Function Digital
Output Selection Table" for a
description of setting values.
Sets the display units for one of the
multi-function output terminals that
is assigned to output the watt hours
(H2- = 39) is the value every
200 ms. An output pulse of 200 ms
is provided for every kWh that
occurs. Intended to drive a counter,
meter or PLC for logging kWh.
0: 0.1 kWh units
1: 1 kWh units
2: 10 kWh units
3: 100 kWh units
4: 1000 kWh units

H2 Multi-Function Digital Output Settings

Closed: A Run command is active or voltage is output.
Closed: Output frequency is 0.
Closed: Output frequency equals the speed reference (plus or
minus the hysteresis set to L4-02).
Closed: Output frequency and speed reference equal the value in
L4-01 (plus or minus the hysteresis of L4-02).
Closed: Output frequency is less than or equal to the value in
L4-01 with hysteresis determined by L4-02.
B.2 Parameter Table
Range Def.
0 to 192
<40>
0 to 4
Description
Control
Mode
Addr. Pg.
O
V/ P
Hex
L
f M
V
E A A A 40B —
0 A A A 40C —
2 A A A 40D —
0 A A A 437 —
Control
Mode
Pg.
O
V/ P
L
f M
V
O O O —
O O O —
O O O —
O O O —
O O O —
341
B