Using Input Terminals S1 Through S7 To Switch Between Lo/Re; Parameters Available In The Setup Group; Setup Mode (Stup); Setup Group Parameters - YASKAWA V1000 Series Installation & Start-Up Manual

4.3 The Drive and Programming Modes
Press . LO/RE will light up. The drive is now in Local.
2.
To set the drive for REMOTE operation, press the
again.

Using Input Terminals S1 through S7 to Switch between LO/RE

■
Switch between LOCAL and REMOTE using one of the digital input terminals S1 through
S7 (set the corresponding parameter H1-01 through H1-07 to "1").
Follow the example below to set the digital input terminals.
Note: 1. For a list of digital input selections,
2. Setting a multi-function input terminal to a value of 1 disables the LO/RE key on the LED operator.
◆

Parameters Available in the Setup Group

Setup Mode (StUP)

■
Parameters used for this drive are classified into A to U. To simplify the drive setup,
frequently used parameters are selected and input into Setup Mode.
1.
To set a parameter, the Setup Mode must be displayed first.
2.
If the parameter setting is insufficient, set the parameters in the Parameter Setting
Mode.
Note: When parameter A1-02 (Control Method Selection) is changed, some parameter set values are
also changed automatically. Execute the A1-02 setting before Auto-tuning.
Table 4.4 lists parameters available in the Setup Group.
Note: This manual also explains other parameters not visible in the Setup Group (A1-06 = 0). Use the
"Par" menu in the Programming mode to access parameters not listed in the Setup Group. The
Setup Group parameters are shown in
Note: Display parameters depend on A1-06.
Parameter
A1-02 Control Method Selection
b1-01 Frequency Reference Selection 1
b1-02 Run Command Selection 1
104
Step
Table 4.4 Setup Group Parameters
Name
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
key
Refer to Parameter List on page
Table 4.4
Refer to Application Presets on page
Parameter
E1-01 Input Voltage Reference
E1-03 V/f Pattern Selection
E1-04 Maximum Output Frequency (FMAX)
Display/Result
⇒
STOP
305.
111.
Name