Offset Frequency - YASKAWA V1000 Series Installation & Start-Up Manual

No. Name
Up/Down Frequency
d4-10 Reference Limit
Selection
d4-12 Stop Position Gain
d7-01

Offset Frequency 1

<22>
d7-02
Offset Frequency 2
<22>
d7-03
Offset Frequency 3
<22>
<11> Default setting value is dependent on parameter o1-03, Digital Operator Display Selection.
<19> Range upper limit is dependent on parameters E1-04, Maximum Output Frequency, and d2-01, Frequency
Reference Upper Limit.
<22> Parameter can be changed during run.
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
Description
Selects which value is used as frequency
reference lower limit if the Up/Down function is
used.
0: The lower limit is determined by d2-02 or
analog input (H3-02/10 = 0). The higher of both
values becomes the reference limit.
1: The lower limit is determined by d2-02.
Sets the gain used by the simple positioning stop
function to fine adjust the position.
d7: Offset Frequency
Use d7 parameters to set the offset frequency.
Added to the frequency reference when the
digital input "Frequency Offset 1"
(H1- = 44) is switched on.
Added to the frequency reference when the
digital input "Frequency Offset 2"
(H1- = 45) is switched on.
Added to the frequency reference when the
digital input "Frequency Offset 3"
(H1- = 46) is switched on.
B.2 Parameter Table
Control
Mode
Range Def. Addr.
O
V/ P
Hex
L
f M
V
0 or 1 0 A A A 2B6
0.50 to
1.00 A A A 2B8
2.55
-100.0
0.0
to A A A 2B2
%
+100.0
-100.0
0.0
to A A A 2B3
%
+100.0
-100.0
0.0
to A A A 2B4
%
+100.0
Pg.
—
—
—
—
B
325