Keys And Displays On The Led Operator - YASKAWA V1000 Series Installation & Start-Up Manual

4.2 Using the Digital LED Operator
No. Display
1
2
3
4
RUN
5
6
STOP
7
8
9
10
11
92
Table 4.1 Keys and Displays on the LED Operator
Name
Data Display Area
ESC Key
RESET Key
RUN Key
Up Arrow Key
Down Arrow Key
STOP Key
ENTER Key
LO/RE Selection Key
RUN Light
LO/RE Light
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
Displays the frequency reference, parameter number, etc.
Returns to the previous menu.
Moves the cursor to the right.
Resets the drive to clear a fault situation.
Starts the drive.
Scrolls up to select parameter numbers, setting values, etc.
Scrolls down to select parameter numbers, setting values, etc.
Stops the drive.
Note: Stop priority circuit. A fast-stop is available by pressing
the STOP key when the drive detects a danger even if the drive
is running by a signal from the multi-function contact input
terminal (REMOTE is set). To avoid stoppage by using the
STOP key, set o2-02 (STOP Key Function Selection) to 0
(Disabled).
Selects all modes, parameters, settings, etc.
Selects a menu item to move from one display screen to the
next.
Switches drive control between the operator (LOCAL) and the
control circuit terminals (REMOTE).
Note: LOCAL/REMOTE key effective during stop in drive
mode. If the digital operator could change from REMOTE to
LOCAL by incorrect operation, set o2-01 (LOCAL/REMOTE
Key Function Selection) to "0" (disabled) to disable LOCAL/
REMOTE key.
Lit while the drive is operating the motor.
Lit while the operator (LOCAL) is selected to run the drive.
Function