Start - YASKAWA V1000 Series Installation & Start-Up Manual

Figure 4.6
Install and wire the drive as explained in Chapters 1, 2 and 3
Adhere to safety messages concerning application of power
For information about the control modes refer to Section 4.5
? b1-01/02 for frequency reference and run command source selection
? H1-
,H2-
? d1-
for multi-speed references if used
? C1-
and C2-
? C6-01 for heavy/normal duty mode selection
? L3-04 if braking options are used
0: V/f control
To
Flowchart A-
1
Run the motor without load, check the rotation direction and operation. Verify, external signal
Couple the load or machine to the motor. Run the machine and check it operates as desired
Fine tune parameters. Adjust application settings (PID, ...) if necessary
Check the machine operation and verify parameter settings.
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual

START

Apply main power on to the drive.
Application Presets
A1-06 used ?
No
Set the control mode in parameter A1-02.
Set the basic parameters:
,H3- ,H4- ,H6- for I/O terminal setting
for accel./decel. and S-curve time settings
Control Mode
A1-02 =
To
Flowchart A-
2
commands to the drive work as desired
Drive is ready to run the application
Figure 4.6 Basic Start-Up and Motor Tuning
4.4 Start-up Flowcharts
Yes
5: Open Loop Vector for PM motors
2: Open Loop
To
Vector control
Flowchart A-
From Flowchart A-1, A-2, or A-3
TO
Refer to section
4.4 Application
Macros
3
4
107