Led Screen Displays; Lo/Re Led And Run Led Indications - YASKAWA V1000 Series Installation & Start-Up Manual

4.2 Using the Digital LED Operator
◆

LED Screen Displays

Display
When the drive detects a alarm
or error
REV Motor is rotating in reverse
Drive Mode
Auto-Tuning
Displays output frequency (Hz)
As
illustrated in
this manual
<1> Refer to the DriveWorksEZ instruction manual for further information.
◆

LO/RE LED and RUN LED Indications

LED Lit
When run command
is selected from LED
operator (LOCAL)
During run
As shown
<1> For the difference between "flashing" and "flashing in short intervals" of the RUN LED, refer to Figure 4.2, RUN
LED and Drive Operation.
94
Lit
Flashing
—
• During deceleration to
stop
• When a run command
is input and frequency
reference is 0
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
Flashing
• When an alarm occurs
• OPE detected
• When a fault or error occurs
during Auto-Tuning
—
When DriveWorksEZ is used
—
Flashing Quickly
• During deceleration at
a fast-stop.
• During deceleration
• During stop by
interlock operation.
Normal state (no fault or alarm)
Motor is rotating forward
Programming Mode
<1>
Run command is selected
— from device other than LED
operator (REMOTE)
During stop
Off
—
Off