Switching Between Local And Remote; Using The Lo/Re Key On The Led Operator - YASKAWA V1000 Series Installation & Start-Up Manual

The example below is continued from page 102. Here, parameter C1-01 is accessed using
the Verify Menu and is changed again to 20.0 s.
To check the list of edited parameters:
1. Turn on the power to the drive. The initial display appears.
2.
Press until the display reads, "Verify."
Press to enter the list of parameters that have been edited
3.
from their original default settings.
Scroll through the list by pressing the
4.
Press the key until C1-01 appears.
Press the
5.
to the left flashes)
◆

Switching Between LOCAL and REMOTE

Entering the run command using the LED operator is referred to as LOCAL, while entering
the run command from an external device via the control circuit terminals or network option
card is referred to as Remote.
WARNING! Sudden Movement Hazard. The drive may start unexpectedly if the Run command is already
applied when switching from LOCAL mode to REMOTE mode when b1-07 = 1, resulting in death or serious
injury. Be sure all personnel are clear of rotating machinery and electrical connections prior to switching
between LOCAL mode and REMOTE mode.
There are three ways to switch between LOCAL and REMOTE.
Note: 1. After selecting LOCAL, LO/RE will remain lit.
2. The drive will not allow the user to switch between LOCAL and REMOTE during run.

Using the LO/RE Key on the LED Operator

■
1. Turn on the power to the drive. The initial display appears.
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
4.3 The Drive and Programming Modes
Step
key.
key to access the setting value.(number farthest
Step
Display/Result
⇒
⇒
⇒
⇒
⇒
Display/Result
⇒
4
103