Setting Up A Serial Or Lan (Ethernet) Port For Annotation Input - Simrad ES80 Reference Manual

Setting up a serial or LAN (Ethernet) port for annotation
input
Several different annotation types may be added to the echogram. They are displayed
on the echogram if this feature is enabled in the
annotations manually, or import information as datagrams using a serial or LAN
(Ethernet) communication port.
Prerequisites
This procedure assumes that:
• You have a vacant interface port on your Processor Unit.
• You are familiar with NMEA and other relevant datagram formats.
• You know how to set up the parameters for serial and local area network (LAN)
communication.
• The interface port is set up with the correct communication parameters.
Context
The
Sensor Installation
and systems. You must specify which communication port to use (LAN (Local Area
Network) or serial port). You can type a custom name to identify the sensor import. In
the list of valid datagram formats, select the format(s) to be accepted by the ES80.
Note
Just making changes and selecting
Select what to install, define the relevant parameters, and then select
Procedure
1 Connect the peripheral system providing the annotations to an available
communication port on your Processor Unit.
This is described in the ES80 Installation manual.
2 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3 On the left side of the
4 Select Annotations to import information from the peripheral system.
5 Select the port you wish to use (serial or LAN).
406273/C
page allows your ES80 to communicate with external sensors
at the bottom of the page will not install anything.
OK
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
dialog box. You can add
Echogram
.
Sensor Installation
Operating procedures
.
Add
.
171