Simrad ES80 Reference Manual page 367

Details
Installed Sensors
The
Installed Sensors
ES80. Select a sensor in the list to edit its interface properties, or to remove it.
Select in the list to add a new sensor interface to the ES80.
New
Type (of sensor)
The ES80 can communicate with several different sensor types. Use this list to
select the sensor type you want to receive information from.
Tip
The page in the
Sensors
overview of all the communication lines and sensors in use. All relevant status
information is provided. You open the
Port
In order to import the data from the chosen sensor, you need to define an input
port. This may be any available Local Area Network (LAN) or serial line on your
Processor Unit.
We recommend that you set up the relevant communication parameters before you
use the port. To set up the communication parameters, use the
page is located in the
I/O Setup
Inspect Port
Once you have selected a serial or Ethernet communication port, select
to inspect the current port parameters. The relevant port setup dialog box opens.
The communication parameters defined for
• : 4800 b/s
Baud Rate
• : 8
Data Bits
• : None
Parity
• : 1
Stop Bits
Some instruments may offer other parameters and/or options. You must always
check the relevant documentation provided by the manufacturer.
Note
You are not permitted to make any changes. To change the communication
parameters, use the
and dialog boxes.
Output
406273/C
list contains all the sensors that are currently installed on the
(Built-In Test Equipment) dialog box provides an
BITE
BITE
Installation
page. The
I/O Setup I/O Setup
Functions and dialog boxes
dialog box from the
I/O Setup
and dialog boxes.
Output
are:
NMEA 0183
page is located in the
menu.
Setup
page. The
Inspect Port
Installation
365