Simrad ES80 Reference Manual page 374

Simrad ES80 Reference Manual
Once the software has established a list of valid interfaces, you can set up and control the
communication parameters. The
and one for Ethernet (LAN) ports. Each list is supported with a set of functions to set up
and monitor the communication ports. Select the port you want to work with and then
select one of the buttons below the list.
Note
You can only use the
ports, and define the communication parameters for each port. On the
page you define which external sensors your ES80 will import information from. To
control the data export, use the
on the menu.
Operation
The page in the
Sensors
of all the communication lines and sensors in use. All relevant status information is
provided. You open the
When you work in the
changes made on a page. You must do this before you continue working on a different
page.
Details
Serial Ports
This table shows the available
serial ports on the Processor
Unit. The list is automatically
populated the first time you open
after a ES80 software
I/O Setup
installation. It then reflects the
initial number of serial ports
available on the Processor Unit. If
you add interface hardware to your
Processor Unit, you must select
to add the new ports to the list.
Add
•
Name
This is the given identity of the serial port. By default, the ports are numbered.
•
Resource
The Processor Unit may have several serial ports. This is the communication
port identification. The ports are normally named COM1, COM2, etc.
372
I/O Setup
page to add or delete serial ports and Ethernet (LAN)
I/O Setup
dialog box. The
Output
(Built-In Test Equipment) dialog box provides an overview
BITE
dialog box from the
BITE
dialog box, you must always select
Installation
page provides two lists; one for serial ports
Output
menu.
Setup
Sensor Installation
dialog box is located
to save the
Apply
406273/C