Simrad ES80 Reference Manual page 172

Simrad ES80 Reference Manual
can define a priority sensor by rearranging the datagrams in a list. You can also define
manual values in case a sensor is unserviceable, or not installed.
The ES80 can communicate with several different sensor types. On the
page you define which external sensors your ES80 will import information
Installation
from. You must also decide which datagram formats that will be accepted.
Note
When you work in the
changes made on a page. You must do this before you continue working on a different
page.
Procedure
1 Open the
Setup
2 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3 On the left side of the
Observe that the
4 Select the sensor you wish to configure in the
5 If you wish to use the built-in datagram priority, select
• With enabled, the priority list is used. Information is imported from the
Auto
sensor at the top of the list. If the sensor fails to provide information for more
than 20 seconds, data from the next sensor is used.
• With disabled, the priority list is not used. Information is imported from the
Auto
sensor at the top of the list. All other sensors are ignored.
6 If you wish to control the datagram priority manually, do not select
To change the priority for a given datagram, select it, and change its location on
the list using the arrow buttons.
7 If relevant, add a manual value for the sensor input.
8 At the bottom of the dialog box, select
9 Repeat for each sensor interface that you need to set up.
10 Continue your work in the
170
dialog box, you must always select
Installation
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
Sensor Configuration
Installation
.
Sensor Configuration
page opens.
list.
Sensor
Auto
to save your settings.
Apply
dialog box, or select
Sensor
to save the
Apply
.
.
.
Auto
to close it.
OK
406273/C