Simrad ES80 Reference Manual page 351

How to open
This page is located in the
Description
Each transducer to
be added to the ES80
configuration must be
selected and identified
individually.
You can only choose
a transducer from the
list. When the
Model
transducer is selected,
you must provide its
serial number, and
type a name that you
choose yourself. Once
a transducer has been
installed, it is listed in the
collected about the transducer, select the relevant transducer in the list.
Tip
Just making changes and selecting
Select what to install, define the relevant parameters, and then select
Once a transducer has been installed, you can verify its operational condition in the
(Built-In Test Equipment) dialog box.
BITE
Details
Installed Transducers
The
Installed Transducers
on the ES80. Select a transducer on the list to edit its properties, or to remove it.
Select on the list to add a new transducer to the ES80.
New
Model
When you add a new transducer, you can only choose a transducer from the list.
The list is generated from a system file on your Processor Unit. It contains all the
transducers that are compatible with the Wide Band Transceiver (WBT), but since
the software is common for several systems there may also be non-compatible
transducers in the list. The list also includes technical specifications for each
transducer. You can not see this information, but it is used by the ES80 to set up
the operational parameters. This allows the Wide Band Transceiver (WBT) to
optimize its performance for the individual transducer models.
406273/C
dialog box. To open, select it on the
Installation
Installed Transducers
at the bottom of the page will not install anything.
OK
box lists all the transducers that are currently installed
Functions and dialog boxes
box. To see the information you have
menu.
Setup
.
Add
349