Relay Output Page - Simrad ES80 Reference Manual

Functions and dialog boxes

Relay Output page

The ES80 allows you to export the same sensor data that was originally imported. This
can "reuse" the same information on other systems. The page is used to set
Relay Output
up and control this export functionality.
Prerequisites
The dialog box is not available when your ES80 is set to Inactive mode.
Output
How to open
This page is located in the dialog box. The dialog box is located on
Output Output
the menu.
Setup
Description
The information imported to the ES80 from
various sensors can also be useful for other
systems on board your vessel. The ES80 allows
you to "re-export" this sensor information. When
activated, the selected sensor information is sent
out on the chosen communication port (serial or
LAN) on the Processor Unit.
The following sensor data can be exported:
• Navigation
• Motion sensor
Once an output type has been defined, it is listed
in the box on the left side of
Installed Outputs
the page. To see the relevant output parameters,
select any output in the list. You can edit the
output parameters, or delete the output format
to stop the export.
Note
In this context, the phrase "sensor" is used to describe an external device providing
information that is useful or essential for ES80 operation. Typical sensors are those
providing navigational information (heading, speed or geographical position) or vessel
movements in the sea (motion sensors).
You can not define the communication port parameters here. If you need to adjust these,
you must select after you have defined the data output parameters. The
I/O Setup I/O
page is located in the and dialog boxes.
Setup Installation Output
395
406273/C