Simrad ES80 Reference Manual page 206

Simrad ES80 Reference Manual
Note
When you work in the
changes made on a page. You must do this before you continue working on a different
page.
Procedure
1 Open the
Setup
2 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3 On the left side of the
4 Verify that the ES80 is set up with minimum one Wide Band Transceiver (WBT) at
the top of the transceiver list.
5 Verify that ES80 operates normally ("pinging") with the Wide Band Transceiver
(WBT) units.
a Close the
Installation
b On the
Operation
c Make sure that the operation is normal.
d Select
Operation
e Shut down the ES80 program and turn off the Processor Unit.
6 Connect the General Purpose Transceiver (GPT) to the Ethernet switch.
7 Turn on the Processor Unit and start the ES80 program.
8 Install the General Purpose Transceiver (GPT) channel(s).
a On the
Setup
b On the left side, select
c Observe that the transceiver(s) you have connected to the Processor Unit are
listed.
Each transceiver is identified with type and serial number. The available
channels on each transceiver are listed separately.
d For each channel, choose which transducer to connect to.
The list of transducers available for installation is defined by those you
installed on the
Note
This is a critical task. Make sure that the correct transducer is selected.
204
dialog box, you must always select
Installation
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
dialog box without making any changes.
menu, set
Operation
, and set it to Inactive.
menu, select
Installation
Transceiver
page.
Transducer
.
Transceiver
to Normal.
.
.
to save the
Apply
.
406273/C